|
DIRECTIONS:
Refer to carpet manufacturer’s specific recommendations.
Condition the area to be installed, adhesive and flooring
at 65°F (18°C) or above for 48 hours before,
during and 48 hours after installation. Floor must
be sound, smooth, dry, clean and free of excessive
moisture or alkali. Remove dirt, wax, loose
paint and all other foreign matter that would interfere
with a good bond such as curing agents and sealers.
- Stir
adhesive.
-
Full spread adhesive using recommended trowel.
- Before
installing stiff or nonporous backed carpets over
nonporous substrates, allow adhesive to set open
to start to develop tack. Install all other carpet
immediately into wet adhesive.
- Within
30 minutes, cut, fit and reposition as recommended
by the carpet manufacturer.
- Roll
carpet in both directions using the recommended
roller (normally 75 pounds) and seal seams as recommended
by the carpet manufacturer. Stiff carpets should
be rolled again after 2 hours. Restrict heavy traffic
over carpet for 24–48 hours.
- Protect
carpet from exposure to water from cleaning and
other sources for a minimum of 30 days after installation.
|
Application
|
Recommended
Trowel
|
Coverage
|
| Latex
and urethane foam backed carpets |
|
144-162 sq. ft.
(16-18 sq yds/gal) |
| All
other carpet backings |
|
90-108 sq. ft.
(10-12 sq yds/gal) |
Click on the icons above to
calculate the amount of product you need!
CLEANUP:
- Wet
Adhesive: Clean, white cloth dampened with soapy
water.
- Dried
Adhesive: Clean, white cloth dampened with mineral
spirits; carefully following warnings on the container.
WARNINGS:
Carefully read and follow all cautions and warnings
on the product label. Refer to the Material
Safety Data Sheet for additional product information.
|
